What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 19.06.2025 02:24
The other is “what does a “fuse” do?”
There are two important concepts here.
One is “what exactly is in a ‘surge protector’ ? ”
Why do older siblings always hate younger siblings?
A fuse is a non-resetable over current circuit protector.
a photo is worth a thousand words.
It seems Mohan does not understand the difference between a comment and an Answer.
Why is digital marketing important?
so, what happens?
First Sentence:
This is where this question deviates from being a 'generic' question, and becomes more specific.
SEC clears Trump Media filing, opening door to multi-billion-dollar Bitcoin buy - The Block
The bolt then partially travels down the line to your home.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
What do you think hell is like?
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
What is lightning?
At one ohm, the resistor has a maximum of 1 watt power.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
but I think this circuit , shows a few more pieces.
He then describes Rainy Season and Lightning.
What does a fuse do?
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
In schematic diagrams this is the symbol for a fuse:
But it can get overloaded, and no longer works.
He then describes the function of a fuse.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
but this device (an Inductor) … impedes the rapid changes in the current.
There are three different concepts here that are getting confused.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
He then asserts :
(Dc diagram shown, AC is similar).
What are mean nicknames to call my sister? She is always so mean to me.
Now when you have a certain ac resistance, then a current flows in a loop.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
The MOV will conduct when the voltage exceeds 50% of line voltage.
This is 'the assistant's answer'
eight
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
nine
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
It also is a device that limits the change in current flow.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Upvotes:
what exactly is a ‘surge’ protector?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
A circuit breaker is similar, but is resettable.
These devices are installed between the “hot” and “neutral” and protective ground.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
These are simplified answers to the original question, and does not change anything I wrote above.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
[old diagram got deleted by accident]
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
This one hit behind the barn.
For this case there are devices called Metal oxide varistors (MOV).
This is where the MOV conducts again, and dissipated the energy.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
But… the neutral is now “floating” because of the 1 ohm resistance.
The third is lightning and “how it gets conducted into a home.”
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
At least they know the answer if they wanted it.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
One
This device then solves the entire problem.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Barnstars:
2024–10–14 [Omar Gharbi Omar Gharbi ]
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
2024–10–10[John johnson John Johnson ]
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
[image of Common-mode choke]
Because the load is inductive, the current lags the voltage.(by a bit).
Edit 2024–10.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Here is a simplified AC power diagram.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
So, the voltage could go up to 500 volts, and the fuse will not open up.
2024–10–16 [ OO OLAOYE OYEBODE ]
I post the exact comment here.
the problem then depends on "how fast does the fuse operate?".
An AC voltage/ current source, and an ac inductive load.